Seastar Solutions Hynautic 04 Series - Troubleshooting

40
Hynautic Hydraulic Engine Controls – 04 Series
FAULT CAUSE SOLUTION
7 Full Throttle on sender gives
idle on engine.
UÊ -ÞÃÌiÊÌÕL}ÊViVÌi`Ê
L>VÜ>À`°
UÊ ,iÛiÊ«ÀiÃÃÕÀiÊvÀÊÌiÊ
ÃÞÃÌi°
UÊ ,iÛiÀÃiÊÌÕL}Ê>ÌÊÌiÊÌÀÌÌiÊ
Ã>Ûi°
UÊ *ÀiÃÃÕÀâiÊÃÞÃÌi°
UÊ -ÞVÀâiÊÌÀÌÌiÊVÌÀ°
TROUBLESHOOTING
HYNAUTIC CONTROLS
6 Engine Throttle tends to
creep toward idle.
UÊ *ÌÊViVÊÛ>ÛiÊ
>vÕVÌ}°
UÊ ->Ûi¿ÃÊÌiÀ>Ê«ÃÌÊÃi>ÃÊ
ÀÊÃÞVÀâ}ÊÛ>ÛiÃÊi>} Ê
`ÕiÊÌÊÜi>ÀÊÀÊ`iLÀð
UÊ ,iÛiÊ«ÀiÃÃÕÀiÊvÀÊ
ÃÞÃÌi°
UÊ ,i«ÀiÃÃÕÀâiÊÌiÊÃÞÃÌi°
UÊ ,i«ÕÀ}iÊÌiÊÃÞÃÌiÊvÊ>À°
UÊ
,iÛiÊ«ÀiÃÃÕÀiÊvÀÊÃÞÃÌi°
UÊ ,iLÕ`ÊÀÊÀi«>ViÊÌÀÌÌiÊÃ>Ûi°
UÊ ,i«ÀiÃÃÕÀâiÊÌiÊÃÞÃÌi°
UÊ ,i«ÕÀ}iÊÌiÊÃÞÃÌiÊvÊ>À°
8
After a long running period
the Throttle tends to go out
of synchronization.
UÊ ->ÛiÊÃÊV>Ìi`Ê>ÌÊ>Êi}iÊ
ÌÊëÌÊÜVÊ>ÃÊV>ÕÃi`Ê
iÝViÃÃÛiÊi>Ì}ÊvÊÌiÊ
ÌÀÌÌiÊÃ>Ûi]ÊÜVÊÊÌÕÀÊ
>ÃÊV>ÕÃi`ÊÌiÊÃ>ÛiÊÌÊ
`iÛi«Ê>ÊÛ>«ÀÊV°Ê
Ê
UÊ Ì>>ÌÊÊ«ÌÊViVÊ
Û>ÛiÊii«}ÊÌÊvÀÊ
vÕVÌ}Ê«À«iÀÞ°
UÊ vÊÌÜÊi}iÃÊ>ÀiÊiµÕ««i`Ê
ÜÌÊ
ÃÞVÀâiÀ]Ê}ÛiÀÀÊÀÊ
ÃÞVÀÊâiÀ¿ÃÊÌiÃÊëÀ}ÃÊ
>ÀiÊÕÌÊvÊ>`ÕÃÌiÌ°
-iÛiÀ>Ê-Õ}}iÃÌi`Ê,ii`iÃ\
UÊ /iÊÕÃiÊvÊi>ÌÊÀiÃÃÌ>ÌÊ
}>ÃiÌÊ>ÌiÀ>Ê>««ÀÝ>ÌiÞÊ
£Én½Ê/V®ÊLiÌÜiiÊÌiÊ
ÕÌ}ÊLÀ>ViÌÊ>`Êi}i°
UÊ -«>ViÃÊLiÌÜiiÊÌiÊLÀ>ViÌÊ
>`Êi}i]Ê>`ÊÃ>ÛiÊ>`Ê
LÀ>ViÌ°
UÊ -i`}Ê>ÀÕ`ÊÌiÊÌÀÌÌiÊ
Ã>Ûi°
UÊ ,iÕÌ}ÊvÊÌiÊÌÀÌÌiÊ
Ã>ÛiÊÊ>ÊiÃÃÊÌÊ>Ài>°
UÊ ,iÛiÊ«ÀiÃÃÕÀiÊvÀÊ
ÃÞÃÌi°
UÊ ,i«ÀiÃÃÕÀâiÊÌiÊÃÞÃÌi°
UÊ ,i«ÕÀ}iÊÃÞÃÌiÊvÊ>À°
UÊ ,i>`ÕÃÌÊëÀ}ÃÊ«À«iÀÊ
ÌiÃ°Ê
NOTE:Êexcessive tension in either
throttle extremes will cause
synchronization problems.
9 Loss of system pressure but
not loss of fluid.
UÊ ÀÊi>ÊÊÀiÃiÀÛÀ° UÊ 7iÊ«ÀiÃÃÕÀiÊÃÊÊÃÞÃÌi]Ê
ÕÃiÊ>ÊÃ>«ÞÊÜ>ÌiÀÊÃÕÌÊÌÊ
w`Ê>Ê>ÀÊi>ÊÊÌiÊÌ>°Ê
7iÊi>ÊÃÊvÕ`ÊÀiÛiÊ
«ÀiÃÃÕÀiÊ>`ÊÀi«>À]Ê
Ài«ÀiÃÃÕÀâiÊÃÞÃÌiÊÌÊnäÊ«Ã°
NOTE:ÊSystem pressure will vary as much as +10 psi due to
temperature changes. When system pressure drops below 70 psi
a leak should be checked for.