EasyManua.ls Logo

Seat ateca - Braking and Parking

Seat ateca
348 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Operation
Upon switching the ignition on/off, the light
of
the
S
T
ART ENGINE STOP
button flashes. With
the en
gine sw
it
ched off, after a few seconds,
the
STOP ENGINE START
button stops flashing
and g
oe
s
out.
With the engine running, the
START ENGINE STOP
button light stays on, indi-
c
atin
g th
at the engine is running. The time
that lapses between the moment the user
starts the engine with the
START ENGINE STOP
button and the lighting changes from flash-
in
g t
o fi
xed will depend on specific engine
size characteristics. Upon switching the igni-
tion off with the
START ENGINE STOP
button, it
s
t
ar
ts flashing again.
In vehicles with the Start-Stop system, the
“My Beat” function also offers additional in-
formation:
When the engine stops during the Stop
phase, the light of the
START ENGINE STOP
but-
t
on s
t
ays on, since, even though the engine
is off, the Start-Stop system is active.
When the engine cannot be stated again
with the Start-Stop system, page 208, and
needs to be started manually, the
START ENGINE STOP
button flashes to indicate
thi
s
f
act.
Braking and parking
Electronic parking brake
Fig. 180 In the lower part of the centre con-
so
l
e: el
ectronic parking brake button.
The electronic parking brake replaces the
h
andbr
ak
e.
Activating the electronic parking brake
The electronic parking brake can be activated
whenever the vehicle is at a standstill, even
when the ignition is switched off. Activate it
whenever you leave or park the vehicle.
Pull and hold the Fig. 180 button.
The parking brake is activated when the
control light of the ›› Fig. 180 button (arrow)
and the red control light of the display in
the dash panel are on.
Release the button.
Releasing the electronic parking brake
Switch the ignition on.
Press the button ›› Fig. 180. At the same
time step hard on the brake pedal or, if the
engine is running, press the accelerator ped-
al slightly.
The control light of the ›› Fig. 180 button
(arrow) and the red control light of the dis-
play in the dash panel go out.
Automatic release of the electronic parking
brake on starting the engine
The electronic parking brake is automatically
switched off when starting if, after the driv-
er's door is closed and the driver's seat belt
fastened, any of the following situations take
place:
On vehicles with an automatic gearbox: A
gear range is engaged or the vehicle is
switched to another one and the accelerator
pedal is lightly pressed.
In vehicles with a manual gearbox: The
clutch pedal is pressed fully before starting
off and the accelerator is pedal lightly press-
ed.
To facilitate certain manoeuvres there are
exceptions that allow the automatic parking
brake to be released without the driver's seat
belt being fastened.
The parking brake can be prevented from be-
ing automatically released by continuously
186

Other manuals for Seat ateca

Related product manuals