Seat ateca - Page 218

Operation
Function
Position of the turn signal lever ››› Fig. 188 or the third lever
››› Fig. 189
Effect
Switching the speed limiter on again
Press button
3
on the turn signal lever or move the third lever into posi-
tion 
.
The speed is limited to the set speed as soon as the speed
you are driving at is lower than the speed set as maximum.
Increasing the set speed of the limiter
Briefly press button
3
on the turn signal lever in the  area or move
the third lever into position 
to increase the speed in small incre-
ments of 1 km/h (1 mph) and set it.
The speed is limited to the set value
Press  on the third lever to increase the speed in increments of
10 km/h (5 mph) and set it.
Hold down button
3
on the turn signal lever in the area  or hold
down 
to increase continuously in increments of 10 km/h (5 mph)
and set it.
Reducing the set speed of the limiter
Briefly press button
3
on the turn signal lever in the  area or press

1
on the third lever to reduce the speed in small increments of 1 km/h
(1 mph) and set it.
The speed is limited to the set value
Press  on the third lever to reduce the speed in increments of
10 km/h (5 mph) and set it.
Hold down button
3
on the turn signal lever in the  area or hold
down 
to reduce the speed continuously in increments of 10 km/h
(5 mph) and set it.
Switching off the speed limiter
Move control
1
of the turn signal lever into position  or the third lever
into position 
.
The system switches off
The values shown in the table in brackets, in
mph, ar
e di
s
played only in instrument panels
with indications in miles.
Going down slopes with the speed limiter
If the set speed of the speed limiter is excee-
ded while driving downhill, soon afterwards
the warning and control lamps flash 
››› page 214 and an acoustic warning may
sound. In this case, use the foot brake to
slow the vehicle or, if necessary, select a low-
er gear.
Switching off temporarily
If you wish to temporarily switch off the
speed limiter, e.g. to overtake, move control
››› Fig. 188
1
of the turn signal lever into po-
s
ition

 or the third lever into pressure
point  or press button
2
on any lever.
Af
t
er o
vertaking, the speed limiter can be
switched on with the previously set speed by
pressing button
3
on the turn signal lever in
the ar
e
a
 or by moving the third lever in-
to pressure point.
216