Seat ateca - Page 266

Operation
–
or in locations
such as the brow of a hill.
●
In order to guarantee good system opera-
tion, keep the ultrasound sensors clean, free
of snow or ice, and do not cover them with
adhesives or other objects.
●
If you use high-pressure or vapour equip-
ment to clean the ultrasound sensors, apply
it directly only very briefly and always from a
distance of more than 10 cm.
●
Retrofitting of accessories to the vehicle,
such as a bicycle rack, may interfere with the
operation of the Parking Aid.
●
In order to familiarise yourself with the sys-
tem, it is advised that you practice parking in
an area or car park that is free from traffic.
There must be good weather and light condi-
tions.
●
The volume and tone of the warnings can
be modified, in addition to the indications
››› page 265.
●
In vehicles without an infotainment system,
these parameters can be modified in a SEAT
Official Service or in a specialised workshop.
●
Please observe information on towing a
trailer ››› page 265.
●
The display on the Easy Connect screen
shows a slight time delay.
Parking Aid operation
Manual disconnection of Parking Aid display
(the audible sou
nds remain active)
●
Press a button on the main menu of the fac-
tory-assembled infotainment system.
●
OR: press the
BACK
function button.
Parkin
g Aid connection
●
Engage reverse (for manual gears) or set
the selector lever to R (for automatic gears).
Parking Aid disconnection
●
Place the selector level in position P, N or D
(for autom
atic gearboxes) or disengage re-
verse (for manual gearboxes). If you set the
lever to N or D, the system will remain active
for approximately 8 seconds before switching
off, except with Top View Camera*, when it
will be switched off immediately after engag-
ing reverse.
Temporary suppression of sound in Parking
Aid
●
Press the  function button. If you have the
Top View Camera* system installed, you can-
not use the temporary suppression of sound
in Parking Aid.
Switch from reduced to full-screen view if the
rear assist is fitted (Rear View Camera
“RVC”)
●
Press the car icon in the reduced view.
If necessary, switch to the rear-assist image
(Rear View Camera “RVC”)
●
Engage reverse gear or turn the selector
lever to position R.
●
OR: press the RVC function icon.
Segments of the visual indication
Fig. 228 Parking Aid display on the Easy Con-
nect
sy
s
tem screen.
The distance to the obstacles can be estima-
t
ed w
ith the help of
the segments at the rear
of the vehicle.
The optical indication of the segments works
as follows:
264