271If and when
Towing eyes
Fig. 182 The front right
section of the vehicle:
Fitting the front towing
eye
Fig. 183 Fitting the tow-
ing eye to the rear of the
vehicle
Fitting the towing eye
– Take the towing ring from the on-board tool set.
– Remove the front cover by pressing down on its left-hand side.
– Remove the rear cover by pressing down on the right hand side,
for FR and Cupra models. For all other versions, remove the rear
cover by pressing on the lower part.
– Screw the towing eye as shown by the arrow anti-clockwise to
the limit position in the front ⇒ fig. 182 or rear ⇒ fig. 183 threa-
ded hole.
Safety First Operating Instructions Practical Tips Technical Specifications
To Next Page
Loading...
