What to do if Seaward Europa Plus Measuring Instruments display 'Hi Cu'?
The 'Hi Cu' message indicates that a high current is expected to be drawn by the Equipment Under Test (EUT). If this is due to a high start-up current and is not expected to exceed 50A, you can override this message by pressing the START/STOP button.
What to do if Seaward Measuring Instruments display 'Lo Po'?
The 'Lo Po' message appears when there is low power, caused by a load less than 60w. If a low load is expected, you can override this message by pressing the START/STOP button.
What to do if Seaward Europa Plus show 'Err 01' with a flashing cross?
The 'Err 01' error with a flashing cross indicates that there is no Earth connection to the tester. In this case: * Have the mains power socket that is supplying power to the tester checked. * If the power socket is working properly, the tester may have an internal fault and should be returned to your Service Agent.
What to do if Seaward Measuring Instruments display 'Err 02' with a flashing cross?
The 'Err 02' error with a flashing cross indicates that there is incoming mains Live voltage on Neutral. In this case: * Have the mains power socket that is supplying power to the tester checked. * If the power socket is working properly, the tester may have an internal fault and should be returned to your Service Agent.
What to do if Seaward Europa Plus display 'Err 07' with a flashing cross?
The error 'Err 07' with a flashing cross indicates memory corruption. Return the device to your Service Agent.
Guidelines and symbols for user safety and hazard identification.
Explanation of the tester's buttons and how to operate them for testing.
Procedures for saving test results to the tester's memory.
Setting the acceptable limit for IEC Lead test parameters.
Explains the sequence of checks performed during the IEC Lead test.
Explains error messages and self-test failures of the tester.
Technical specifications for the AC Earth Continuity test.
Technical specifications for the DC Earth Continuity test.
Technical specifications for the Insulation test.
General| Display | LCD |
|---|---|
| Weight | Approx. 4.0kg |
| Dimensions | W310mm x H140mm x D270mm |
| Power Socket Test | Yes |
| Pass/Fail Indication | Yes |
| Power Supply | Rechargeable battery |
| Measurement Types | Earth Bond, Insulation, Leakage, RCD, Power Socket |
| Measurement Range | Varies by test type |
| Accuracy | Varies by test type |
| Test Current | Varies by test type |
| Display Digits | 3.5 digits |
| Insulation Test Voltages | 250V, 500V |
To Next Page
