Sebo Dart User Manual

TROUBLE-SHOOTING GUIDE
13
PROBLEM
Does not turn on
Bag full indicator shows
Poor Suction
Does not pick up
Filter bag door won’t
fully close
Filter bag doesn’t fit into
position
REASON
1. Not plugged into working outlet.
2. Cord worn, cut or broken.
3. The power control switch is
set to the “OFF” position.
1. Bag full.
2. Clog in hose, power head neck,
brush or head
1. Exhaust filter dirty.
1. Hose is not connected correctly
into the connecting tube.
2. Filter bag cover not closed.
1. Cover release flap not fully closed.
2. Bag not inserted properly.
3. Cover latch spring bent.
1. Motor protection filter not
properly inserted.
SOLUTION
1. Use another outlet.
2. Replace cord.
3. Slide switch to the ON
position. See page 8.
1. Replace filter bag. See page 11.
2. See Clog Removal on page 12.
1. Replace exhaust filter. See page 11.
1. Check the safety ring. See page 12.
2. See below.
1. Reinsert bag. Lock the cover
release flap (10) down firmly.
2. Reinsert bag. Lock the cover
release flap (10) down firmly.
3. Straighten cover latch spring.
1. Remove the filter bag and make
sure the motor protection filter is
seated correctly See page 11.
Always unplug vacuum from outlet before dismantling any part of the machine!
!

Sebo Dart Specifications

General

Type	Upright
Power	700 W
Bagged/Bagless	Bagged
Filter Type	S-Class Filter
Warranty	5 years
Dust Capacity	3.5 L
Filtration	S-Class