IDENTIFICATION OF PARTS
7
Place the power head (16, 28) or floor tool (29, 30) on the floor with the
power head neck (20) upright. Hold the vacuum vertically and Insert the
suction opening of the vacuum into the neck of the head or tool. Push firm-
ly and evenly downward until the tool release button (14) snaps into the
locked position - see figure 1.
Insert the black end of the hose (6) into the connection on the filter cover
(8) - see figure 2a. Insert the hose handle (19) into the suction opening (18)
on the side of the vacuum - see figure 2b.
Note:
Hose must be fully insert-
ed to activate the power head. Press the hose into place on the side of the
machine.
Install the attachment clip (21) to the handle assembly (5) using the includ-
ed screw. Insert the crevice nozzle and dusting brush into the clip - see fig-
ure 3.
Standard Attachments
21. Attachment clip
22. Crevice Nozzle
23. Dusting Brush
1. Handle grip
2. Upper cable hook
3
. On/Off switch, suction control slider
4. Power cable
5. Handle Assembly
6. Hose
7. Bag full indicator
8
. Filter bag cover
9. Filter bag housing
10. Filter bag housing release latch
11. Carrying handle
12. Exhaust filter
13. Exhaust filter clamps
14. Tool release button
15. Foot pedal
16. Power head
17. Cable hook
18. Suction opening
19. Hose handle
20. Power head neck
ASSEMBLY
21
22
23
Figure 1 Figure 2
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
1
2
4
6
13
17
12
11
18
19
20
15
Figure 3
a.
b.
To Next Page
Loading...
Need help?
General
