P/N VT-108731-IE, Manual revision: B
Figures
Figure 2-1, OMNI™ Sealer with Hand-Held and Bench-Top Sealing Heads. 2-2
Figure 2-2, Model 2600 OMNI™ Sealer Components ........................................... 2-4
Figure 2-3, OMNI™ Power Source Power Interface Panel ......................................... 2-6
Figure 2-4, Serial Plate Label for OMNI™ Power Source ....................................... 2-6
Figure 3-1, RF Power Cable Attachment (For Use with a Model 1105) ............... 3-2
Figure 3-2, Model 2605 Bench-Top Sealing Head Cable Attachment ..................3-3
Figure 3-3, Correct Technique for Holding the Sealing Head ................................ 3-4
Figure 3-4, Incorrect Technique for Holding the Sealing Head ............................. 3-5
Figure 3-5, Maintaining Compression During the Entire Sealing Process . . . 3-5
Figure 3-6, Releasing the Sealing Head Lever at Seal Completion ....................... 3-6
Figure 3-7, Correct Sealing Method ............................................................................. 3-7
Figure 3-8, Incorrect Sealing Method .......................................................................... 3-8
Figure 3-9, Repeating the Seal Process ........................................................................... 3-8
Figure 3-10, Multiple Seal Spacing ........................................................................ 3-10
Figure 5-1, Releasing Fuse Holder Latch .................................................................... 5-3
To Next Page
Loading...