Figure 12
Input device name, then Click “ok”, entering into “Upload/Download” interface᧶
The blue progress bar shows the uploading progress
B. To Upload the fingerprint and card data to new software in PC
To input all the employee information in “All Employee Info Management”, operated
following the above step A to upload employee’s info in each device’s data to PC.
2). To Download Data᧶
To download the fingerprint and card data from software in PC to
device. It is applied to following cases᧶
A. If all enrolled data in device were deleted after initializing the device,
B. If needed to manage several devices, it is available to manage all data in one device by
putting it in the management center then to select some employee to download their data
to specified devices.
Operation procedures:
1. To select the device in the left of “Upload/Download” interface→all users’ information
list will be shown in middle box (shown as Figure 10)
2. To select the users or all users click “select all”
3. To select the device to be downloaded᧤tick the check box before the ‘device ID’᧥
4. To click “from PC to device ”: the blue progress bar shows the uploading progress.
5. To click “close” to finish downloading.
8.1.6 To Scan Device
For detecting the state of RS485 network (online or offline).
Click “Device Scan” in Figure2 to scan device in Main interface.
To Next Page
Loading...
