To Next PageTo Next PageWhy is the keypad light off on my Sebury S Touch-s Intercom System?
If the keypad light on your Sebury Intercom System is off, it may be due to an improperly set keypad light mode. To resolve this: 1. Set the keypad light to always ON or automatic mode. 2. In automatic mode, the keypad light will activate when someone approaches.
Why is the reading distance too close on my Sebury Intercom System?
If the reading distance is too close on your Sebury Intercom System: 1. Ensure you are using an original Sebury-made card. 2. Wire the power supply and access host shell to a ground wire to avoid power supply interferences during card reading.
Why set user PIN failed on my Sebury Intercom System?
If you are unable to set a user PIN on your Sebury Intercom System, consider the following: 1. Ensure you are using the correct PIN setting method. The first digit of the user's PIN should correspond to the user's ID: 1 for Zone 1 or 2 for Zone 2. 2. The user PIN cannot be '1234'. 3. User PINs must be 4-6 digits long. 4. Setting a PIN under card reader mode is not allowed.
General| PIN Length | 4-6 digits |
|---|---|
| Waterproof | IP65 |
| Weatherproof | Yes |
| Operating Voltage | 12V DC |
| Operating Humidity | 90% RH |
| Wiring Distance | Up to 100m (depending on cable) |
| Display | No |
| Camera | No |
| Night Vision | Yes |
| Alarm Output Load | 12V DC/1A |
Overview of the access control system components and capabilities.
Key characteristics and functionalities of the access control devices.
Technical details for Access Host and i Box components.
Instructions for drilling holes for mounting the access host.
Steps to attach the bracket and mount the main access host unit.
Procedure for securing the device with safety screws.
Guidance on installing the i Box and the exit button.
Steps for installing the door lock mechanism.
Instructions for connecting the electrical wiring of the system.
Process for adding users using the Manager Add Card.
Procedure for removing users with the Manager Delete Card.
Configure door access using a single card.
Set up door access for multiple cards.
Enable door access via card and PIN combination.
Allow access using either card or PIN.
Configure relay modes (Pulse or Toggle) for device control.
Guide on how to modify a user's Personal Identification Number.
Configuration options for the door bell function.
Settings for the alarm triggered by tampering.
Alarm configuration for illegal door opening.
Setting up duress alarms for security.
Procedure to disarm or reset active alarms.
Guide for system administrator configuration options.
Detailed programming for user settings in Zone 1.
Detailed programming for user settings in Zone 2.
Configuration for advanced system applications and modes.
Detailed setup for the Wiegand reader operational mode.
Configuration for single door access control.
Setting up the device for automatic operating mode.
Configuration for standalone operation of two doors.
Setup for two doors using an external reader.
Configuration for interlocked operation of two doors.
Setting up anti-passback for a single door.
Configuration for anti-passback system for two doors.
Troubleshooting for issues with short reading distance.
Solutions for failed user PIN setting.
Resolving issues when the door does not open after PIN entry.
Troubleshooting for unexpected alarm activations.
Diagnosing and fixing issues with card reader non-responsiveness.
Solutions for the keypad backlight being off.
Steps to resolve inability to enter admin settings.
