To Next PageTo Next PageWhy is the keypad light off on my Sebury S Touch-w?
If the keypad light on your Sebury Intercom System is off, it may be due to an improperly set keypad light mode. To resolve this: 1. Set the keypad light to always ON or automatic mode. 2. In automatic mode, the keypad light will activate when someone approaches.
Why is the reading distance too close on my Sebury S Touch-w Intercom System?
If the reading distance is too close on your Sebury Intercom System: 1. Ensure you are using an original Sebury-made card. 2. Wire the power supply and access host shell to a ground wire to avoid power supply interferences during card reading.
Why set user PIN failed on my Sebury S Touch-w?
If you are unable to set a user PIN on your Sebury Intercom System, consider the following: 1. Ensure you are using the correct PIN setting method. The first digit of the user's PIN should correspond to the user's ID: 1 for Zone 1 or 2 for Zone 2. 2. The user PIN cannot be '1234'. 3. User PINs must be 4-6 digits long. 4. Setting a PIN under card reader mode is not allowed.
Details the sTouch-w/sKey-w/sTouch-s/sKey-s system, connecting host and i Box via Wiegand Bus.
Highlights features like aluminium case, waterproof rating, split design, and multiple working modes.
Lists detailed electrical and environmental specifications for the Access Host and i Box.
Identifies front and back panel components of the sTouch/sKey access host models.
Provides instructions for drilling holes and fixing the bracket for access host installation.
Guides on installing the i Box, exit button, lock, and performing initial system wiring.
Explains interface principles and provides diagrams for door bell, alarm, and lock connections.
Procedures for adding and deleting user cards using manager cards.
Configures door access via single card, multiple cards, or card/PIN combinations.
Explains Pulse Mode and Toggle Mode for controlling door locks and other devices.
Instructions for changing user PINs and configuring door bell functionalities.
Details on setting up Anti Tamper, Door Contact, and Anti-duress alarms.
Steps to restore the device to its default factory settings, retaining user data.
Table detailing LED colors and buzzer sounds for various operational statuses.
Guide for setting master codes, manager cards, and duress options.
Instructions for adding, deleting, and managing user cards and PINs.
Settings for keypad transmission, relay time, keypad backlight, and optional configurations.
How the access host functions as a Wiegand reader with specific settings.
Configuration and wiring for operating the access host as a standalone unit for one door.
Operation of the host in automatic mode, functioning as standalone or Wiegand reader.
Configuration for controlling two separate doors using the access host.
Setup for using the access host and an external reader to control two doors.
Configuration for interlocked operation of two units for enhanced security on two doors.
Setting up a single door system with anti-passback to prevent unauthorized entry/exit.
Configuration for a two-door anti-passback system, often used in parking lots.
Visual representations illustrating different system application scenarios.
Provides solutions for common problems related to PIN entry, reading distance, and keypad status.
Information on how to contact technicians for further assistance with the system.
Lists all included items for the Touch / Key access control unit.
Lists all included items for the S Button accessory.
General| Brand | Sebury |
|---|---|
| Model | S Touch-w |
| Category | Intercom System |
| Language | English |
