Seca 780 - Recalibration; Technical data

7
Congratulations
In the seca 780/783 electronic personal
scale you have acquired a highly accurate
and at the same time sturdy piece of equip-
ment.
seca has been putting its experience at the
service of health for over 150 years, and as
market leader in many countries of the world,
is always setting new standards with
its innovative weighing and measuring deve-
lopments.
The seca 780/783 electronic personal scale
is designed for private use and also for use in
public institutions.
Weight display can be switched between
kilogrammes (kg), pounds (Ibs) and stones
(sts).
Safety
Before using the new scale, please take a
little time to read the following safety instruc-
tions.
• Follow the instructions in the instructions
for use.
• Use only the type of battery stated (see
,,Changing the batteries“).
• Use only the mains unit supplied (783).
• Do not drop the scale or subject it to
violent shocks.
• Have repairs carried out only by
authorised persons.
Before you start …
Setting up the scales
Remove all packaging.The scales are easiest
and safest to put together if you place the
weighing platform face-down on a table
(ideally over 77 cm high).
Fitting the column
The column with the LCD display is fi tted to
the weighing platform.
– Guide the connecting cable through the
opening.
– Place the column in the opening.
– Screw the column to the weighing
platform from underneath. If necessary,
lay the scale carefully on its side in order to
tighten up the screws.
– Connect the plug of the connecting cable
to the rear of the scale.
– Then stand the scale upright again.
Position of
connecting bolts
Cable duct
Installing and changing batteries
Insert batteries in the battery bracket. Press
the lock in the lid of the battery compartment
in the direction of the word “BATTERY” and
fl ip open the lid. Press the clip of the battery
cable onto the buttons of the battery bracket
and insert this in the battery compartment.
Close the lid again and engage the lock
– that’s it.
Mains operation (seca 783 )
The scale is powered by a mains unit. The
connection socket for the mains unit is in the
base of the scale.