Model 882/pragma 883 31
GB
7. Cleaning
Clean the rubber surface and the housing as required using a domestic cleaning agent or
commercially-available disinfectant. Follow the manufacturer’s instructions.
8. What do I do if…
… no weight is displayed when a load is placed on the scale?
– Is the scale switched on?
– Check the batteries.
... the display stays dark?
– Is the plug contact on the scale properly connected?
…
0.00 does not appear before the weighing operation?
– Press the Start key again – there must not be any load on the scale
… ---- appears instead of 0.00 before weighing?
– Press the Start key again – there must not be any load on the scale.
… one segment is illuminated constantly or not at all?
– The relevant segment has a fault. Inform Servicing.
… the display shows ?
– Battery voltage is running low. Change the batteries in the next few days.
… batt appears in the display?
– Batteries are empty. Put in new batteries.
… St0p appears in the display?
– Maximum load has been exceeded.
… the display flashes?
– Take the load off the scale and press the Start key twice. Wait until
0.00 appears and
then weigh again.
… the display appears?
– The ambient temperature of the scale is too high or too low. Place the scale in an
ambient temperature between +10 °C and +40 °C. Wait about 15 minutes for the
scale to adapt to the ambient temperature and then weigh again.
… the display E and a number appear?
– Press the Start key. The scale will then work normally again. If this is not the case,
inform Servicing.
To Next Page
Loading...
