EasyManua.ls Logo

SECOLink KM20B - Stay Arming Mode; Max Away Arming Mode; Night Arming Mode; Forced Arming

SECOLink KM20B
5 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Stay arming mode – AA
Use this mode when you are staying at home, but expect someone to use the entrance door later. Interior zones will not be
protected and you may freely move throughout the premises. Late arrivals can enter through the designated entrance door
without causing an alarm, but they must disarm the system within the entry delay period or an alarm will occur. There are two
ways to arm your security systems Stay arming mode:
F-key: for EU countries – , ; for non EU countries is available .
via Menu: , Arming , Stay , , Parts: .
A A
ENT
A A
ENT
ENT ENT ENT ENT
Max Away arming mode – AAA
Use this mode when no one will be staying on the premises for a long period of time (e.g., vacations). Close all protected
perimeter windows and doors before arming. When armed in Max Away mode, all zones will be secure, entry delay is turned off,
and the system will sound an alarm if a protected zone is violated. There are two ways to arm your security systems Max Away
arming mode:
F-key: , .
via Menu: , Arming , Max Away , , Parts: .
A A A
ENT
ENT ENT ENT ENT
Night arming mode – C
Use this arming when you are staying inside the premises and require increased security. Interior zones are left disarmed and
you may freely throughout the premises. In the event of someone opening the door there will not be and entry delay and the
alarm will sound. This arming mode is effective when doors and windows are secured with opening sensors, or glass break
detectors are installed. There are two ways to arm Night Arming mode:
F-key: for EU countries – , ; for non EU countries is available .
via Menu: , Arming , Night , , .
C
ENT
C
ENT
ENT ENT ENT ENT
Short user manual
KM20B, KM20BT keypadsKM20B, KM20BT keypads
Intruder alarm system
Forced Arming – F , AAAA
Use this arming mode when zones are violated or any of the sensors are broken. All the remaining sensors will be armed. There
will be an entry delay after opening the entry/exit door. There are two ways to arm security systems Forced arming mode:
F-key: for EU countries – , ; for non EU countries is available .
via Menu: , Arming , Forced Arming , .
F
ENT
F
ENT
ENT ENT ENT
Partial Arming
F-key: for EU countries – , , .
A
1
ENT
Partitions allows you to break up a large area into smaller sections. Use this to arm certain areas of the premise
while leaving other areas disarmed, or to limit other user access in specific areas. For example: An alarm system is installed in a
two-story house. During night time the ground floor isn't being used and all sensors of this partition are armed. There will be an
entry delay in the event of someone opening the door. Below is an example of how to arm a first partition (one of two) in Away
mode.
arming mode
F - key A
F - key A
AWAY, arming
AWAY, arming
Press key.
A
Press key.
A
12/09 08:11 ..
READY TO ARM
12/09 08:11 ..
READY TO ARM
Press key.
1
Press key.
1
Ground floor
Ground floor
First partition is selected.
Press key.
ENT
First partition is selected.
Press key.
ENT
Away:
PIN:ÜÜÜÜ
Enter your PIN code .
F-key: for non EU countries is available .
A
1
ENT
via Menu: , Arming , Away , , .
ENT ENT ENT
1
12/09 08:11 ..
READY TO ARM
12/09 08:11 ....
READY TO ARM
Main Menu:
| Arming }
Main Menu:
| Arming }
Arming:
| Night }
Arming:
| Pre-alarm }
Arming:
| Away }
Press key.
ENT
Press key.
ENT
Press key.
ENT
Press twice key.
Press key twice.
Press key.
ENT
Away:
PIN:ÜÜÜÜ
Pre-alarm:
PIN:ÜÜÜÜ
Press key.
ENT
Enter your PIN code .
Enter your PIN code .
Ground floor
Press key.
1
Ground floor
First partition is selected.
Press key.
ENT
Arming and disarming of security barrier, Pre-alarm mode
Microwave or infrared rays based security barriers, outdoor PIR detectors, which are connected to the system, can be armed by
Pre-alarm mode. In the event of someone crossing this electrical barrier the system will sound an alarm without sending an
alarm message to Central Monitoring Station. The Pre-alarm mode can be turned on and turned off in the same way as described
below. For a more convenient control of Pre-alarm mode it is recommended to create special F-keys during and installation
process.
Ground floor
To select press key.
Press to confirm.
1
ENT
via Menu: , Pre-alarm , , Parts: , .
ENT ENT
1
ENT
Parts:#2
Parts:#2
Parts:12 Parts:#2
Parts:X2
To Exit:
030 seconds
Leave the premise.
To Exit:
030 seconds
Leave the premise.
To Exit:
030 seconds
Leave the premise.
Page 2

Other manuals for SECOLink KM20B

Related product manuals