for EU countries – , Away , .
ENT
for non-EU countries – , Away .
ENT
PIN code: .
Away arming mode
Use this mode for premises protection when no one will be staying inside. When armed in Away mode, all zones will
be secure and the system will sound an alarm if a protected zone is violated. User must disarm the system within the
entry delay period or an alarm will occur. There are three ways to arm your security system's Away arming mode:
Ways of arming
14:1510/02 +25°C
Return to upper menu level, alarm/
trouble review and clear
System information
Zone bypass
Sound settings
Disarm
Arm
Partition status
This key is used for partition review,
also for marking all partitions, or
selecting another element
This key is used for zone review, also
for marking the partitions and other
elements of the system
System status
Zones, partitions
Entering selected menu item, value
entry, selection confirmation
Navigation keys
Emergency keys
Short user manualIntruder alarm system
KM24, KM24A, KM24G keypadKM24, KM24A, KM24G keypad
SECOLINK KM24, KM24A, and KM24G are user-friendly new concept keypads. Large graphic display with helpful texts and
backlit keys simplify the use of an alarm system. There are options to customize main screen information and change contrast
or backlight intensity of LCD and illumination of keypad keys. User can easily follow the blinking keys as prompts to operate the
system without any commands needed to memorize. Arming, disarming, and zone bypassing is simple and can be done
intuitively. The main keypad functions and primary display view are shown in the figure below.
READY TO ARM
1st Floor
2nd Floor
Functional key
Bedroom +25°C Rad.Stat.: perfect
Living room +24°C Rad.Stat.: perfect
Info bar (KM24G)
Temperature (KM24A, KM24G)
Time
Date
Page 1
The system can be armed in two ways: with a special key, or by entering a PIN code (symbol is used to prompt you to
enter your PIN code). When Arming is activated using the key, it is necessary to mark the partitions (areas), which will be
armed (use keys ... or to mark a particular partition (area), or use to mark all partitions and proceed by pressing to
confirm the selections). If arming is activated by entering a PIN code, your system will be armed in Away mode.
1111
4
GHI
!
4
GHI
!
4
GHI
!
4
GHI
!
####
ENT
10/02 . . 25°C 14:02
2nd Floor
1st Floor
READY TO ARM
Press [ ] to select mode
Press [1]..[4] to select part.
Press [ENT] to arm
Away
Arming All To Exit
partitions 30
10/02 . . 25°C 14:02
2nd Floor
1st Floor
READY TO ARM
Press [ ] to select mode
Press [1]..[4] to select part.
Press [ENT] to arm
Away
Arming To Exit
30
seconds
seconds
Enter PIN
ÜÜÜÜ
Press the key.
Press the key.
Press the key.
ENT
Press the key.
ENT
Enter your PIN code . Leave the premises.
Leave the premises.
10/02 . . 25°C 14:02
2nd Floor
1st Floor
READY TO ARM
To Exit
30
seconds
Enter PIN
ÜÜÜÜ
Enter your PIN code . PIN code entry. Leave the premises.
Arm
To Next Page
Need help?
General