EasyManua.ls Logo

SECOLink KM20B - System Disarming and Zone Management; Disarming the System Using Your PIN Code; Partial Disarming; Bypassing Zone

SECOLink KM20B
5 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Short user manual
KM20B, KM20BT keypadsKM20B, KM20BT keypads
Intruder alarm system
Bypassing zone – B
Bypassing a zone allows you to leave a door or window opened while arming the rest of your security system. There are two
different types of bypass: temporal or permanent. Temporal bypass is used for a one time arming and disarming cycle.
Permanent bypass is used until the user unbypasses the zone. Enter the zone number you would like to bypass. THIS MUST
BE A TWO DIGIT NUMBER. The zone will be marked as " ". To bypass the zone for a long time (permanent) the last number
should be pressed and held for 2 sec. The zone will be marked as " ". When all zones are marked press key. The same actions can be
performed by choosing the zone with the keys or and by marking with the key (short press - temporal, long - permanent).Bypass
procedure can be made:
ENT
Abort arming
Clear key is used for selecting and aborting procedures. For example, if the exit delay is in process and you want to abort
arming press the clear key, enter PIN code, and confirm it with key.
CLR
CLR
ENT
trouble
armed
alarm
Arming system with troubles
EU standards do not allow the use of a troubled security system. Yellow LED light on keypad will turn on and arming of the system
with previously described ways will not be possible. It is necessary to immediately eliminate system troubles, inform CMS, and
the company that had installed your system. The system detects troubles of its own modules as well as other common problems
such as 230V disappearance in AC line, a disconnected phone line due to repairs, or a battery discharge. In exceptional cases it
is possible to bypass certain troubles for a short period of time and arm the system as usual. To arm a system with troubles
please do the following:
Press the key once and a message describing system troubles will be shown on the display. Press key again and the
yellow trouble LED light will start to blink rapidly. Blinking duration is 30 seconds and during this time it is possible to activate
Arming of your system as usual.
CLR CLR
Emergency keys
To activate an emergency function press at once two event specific keyslisted below and hold it for at least 1 second. Premises
must be secured by CMS for these functions to activate. An audible emergency loud siren will occur showing a related message
on the keypad screen.
Fire alarm: + .
Medical alarm: + .
Panic alarm: + .
A 1
B
!!
4
!!
C 7
To Disarm the System Using Your PIN Code Upon Entering the Premise
Entry delay gives you time to disarm the system when you enter through the designated entrance door. You must disarm the
system before the entry delay period ends to avoid an alarm occurrence. There are three ways to disarm the system using your
PIN code:
F-key: , or , .
PIN code: .
via Menu: , Disarming , All partitions , .
F
0
ENT
B
!!
B
!!
ENT
ENT ENT ENT
12/09 08:11 ....
READY TO ARM
12/09 08:11 ....
READY TO ARM
F - key B
F - key B
Bypassing Zones
Bypassing Zones
Press key.
B
!!
Press key.
B
!!
Press key.
ENT
Press key.
ENT
Zone named Window is
violated (!)
Zone named Window is
violated (!)
Window
Window
Window
Window
Window
Window
Zone:!2345
Zone:!2345
Zone:!2345
Zone:!2345
Zone:x2345
Zone:X2345
Press key.
Press key and hold it
for 2 seconds.
Zone is bypassed
temporary
Zone is bypassed
permanently
F-key: , mark the zone with ... or , .
B
!!
ENT
0 9
ENT
via Menu: , Zone Bypass , , mark the zone with ... or , .
ENT ENT
0 9
ENT
Partial disarming
Partial disarming is used when you want to disarm certain areas while leaving other areas armed, or to limit access to certain
areas to other users. Below is an example explaining how to disarm a first partition of two.
F-key: , , or , , .
F
0
1
ENT ENT
B
!!
B
!!
1
ENT ENT
via Menu: , Disarming , Selected partit , , .
ENT ENT ENT
1
ENT
Entry Delay
030 seconds
Main Menu:
| Arming }
Main Menu:
| Disarming }
Disarming: Disarming:
| | All partitions Selected parti} }
Press key.
ENT
Press key. Press key.
ENT
Press key. Press key.
ENT
Enter your PIN code .
Press , keys.
F
0
F - key F0 Selected partit:
DISARMING all PIN:ÜÜÜÜ
Press key.
1
Enter your PIN code . Press key.
ENT
First partition is
disarmed.
Ground floor
Parts:1# 12/09 08:11 .#
PARTIALLY ARMED
Entry Delay
030 seconds
Selected partit:
PIN:ÜÜÜÜ Ground floor
Parts:1# 12/09 08:11 .#
PARTIALLY ARMED
Press , then key.
1
ENT
First partition is
disarmed.
Page 3

Other manuals for SECOLink KM20B

Related product manuals