set in [Main Menu] > [System Settings] > [Tour Settings];
“PTZ Activation”: Set the recorder to call the preset point of the selected channel pan/tilt when the
alarm occurs, and cruise or patrol between points;
Note: In the analog channel mode and the analog channel in the hybrid channel mode, the PTZ
linkage is the camera PTZ corresponding to the analog channel. In the network channel, the PTZ
linkage is the PTZ of the front-end network camera corresponding to the channel. Before connecting
the PTZ, you need to set the PTZ preset point, inter-point cruise, interval time and other parameters in
[Quick Menu] > [PTZ Control]; the analog channel needs to be connected to the RS485 control line.
“Show Message”: Set the recorder to pop up the alarm information dialog box in the local preview
screen such as VGA, HDMI, etc. when the alarm is triggered;
“Send Email”: When this function is enabled, the recorder sends an alarm email to the specified
mailbox when the motion detection alarm is triggered.
Note: Before using this function, you need to set the Outbox and Inbox in [Main Menu] > [System
Settings] > [Network Service] > [Email] and ask the recorder to connect to the Outbox Server.
“FTP upload”: When this function is enabled, the recorder will upload an alarm video or picture to the
specified FTP server when the motion detection alarm is triggered.
Note: Before using this function, you need to set the FTP server to be used in [Main Menu] > [System
Settings] > [Network Service] > [FTP] and ask the recorder to connect to the FTP server.
“Buzzer”: When the recorder is set to trigger an alarm, the buzzer on the local host of the recorder
issues a “beep” sound;
To Next Page
Loading...
