Set alarm mode:configuration,manual,close
PS:Some devices don’t support this function
No hard disk, hard disk error, insufficient hard disk space,
network disconnection event, IP conflict time, set linkage
parameters: screen prompt or buzzer
Determine algorithm rules: perimeter alert, item care, video
diagnosis.
Set rules: display trace, sensitivity, minimum moving
distance, alert mode, and set linkage parameters: arming
time period, alarm output, screen prompt, record, pan/tilt,
round robin, buzzer, EMAIL, FTP upload, mobile phone
report
Set system time, date format, time format, language, hard
disk full operation, device id number, video signal standards,
output mode, standby time, device name, daylight saving
time
Set the main coding and combined coding parameters for
each channel: coding mode, resolution, frame rate, code
stream control, picture quality type, code stream value, one
frame interval parameter, video/audio enable
Set basic network parameters, and set DHCP, DNS
parameters, network high-speed download, network
transmission strategy
PPPOE, NTP, Email, IP permissions, DDNS parameters,
PMS, FTP, alarm center, cloud service, RTSP, wireless
dialing, WIFI, etc.
Set the channel name of the front end, preview prompt icon
status, transparency, area coverage, time title, and overlay of
channel titles.
Set channel, PTZ protocol, address, baud rate, data bit, stop
bit, check
Set protocol, address, baud rate, data bit, stop bit, check.
PS:full digital channel displays RS485 device
Set serial port function, baud rate, data bit, stop bit, check
Set the mode and interval of the round robin
Set round robin mode and interval time of Spot output end
Set the channel mode, view the channel status, and set the
parameters of the digital channel.
To Next Page
Loading...
