Seeed SenseCAP M2 - Checking the Gateway Connection Status

SenseCAP
8
1.4 Checking the Gateway Connection Status
After powering on the gateway, there are two ways for you to
check the gateway working status::
1) LED Indicator
Mode
Description
Green
Solid
Gateway is healthy and the internet is well connected.
Slow blinking
Gateway is booting, please wait.
Blue
Solid
The gateway is ready for internet connection.
Further configuration is needed.
Slow blinking
Configuration mode, and will auto exit after 5 mins if no activity.
Fast blinking
Press the button for 3 0 s until the indicator show fast flash will
trigger the factory reset.
Orange
Slow blinking
Firmware is updating, and please do not power off the
gateway or disconnect the internet.
White
Solid
Gateway is only with a factory firmware, and will be updated
to the latest firmware automatically when it is connected to
the internet.
Red
Solid
Hardware issue or internet connection failure.
Slow blinking
Gateway not connected to the LNS.
2) SenseCAP Mate APP
In the SenseCAP Mate App, “Online status” indicates “Online” when
the gateway is connected to the network and can receive and transfer
sensor data.
Please refer to the next chapter for obtaining the SenseCAP App.