English version
V0916
Page 6
A. SETTING UP THE MACHINE
1. Unpacking
1. Remove the packing case from the machine.
2. Set up and secure the machine on its work table.
3. Make sure the press is cold before picking it up. Carry the press holding both platens (upper and lower),
which should be in the closed position.
4. Remove the transport safety screws before opening the press.
5. Plug in the press (230 Volt + Earth / 50 or 60 Hz).
B. TRANSFER CYCLE
1. Press the main switch at the back of the machine to turn the power on.
2. Set the temperature.
3. Set the pressing duration.
4. Set the pre-heat duration if necessary.
5. Adjust the pressure (to suit the type of transfer).
6. Place the T-shirt on the lower platen.
7. Position the transfer sheet correctly.
8. When the heat platen is at the correct temperature, press the dual-operated buttons to lower it into
position.
9. The timer will start when the platen is pressed against the T-shirt.
10. The press will open automatically when the timer has finished.
11. The cycle can be stopped early by pressing the stop button on the control panel. The press will open
automatically.
12. If the auto-swing is engaged, the machine will also swing open to the side automatically.
To Next Page
Loading...