EN
To set a different Satellite or LNB
Select Satellite mode, press MENU key, navigate down to
the Dish Setup option, press OK. You will see the Satellite
Dish Setup menu.
To set Multiple Satellites and LNBs (only possible
on multi-LNB dish, switch systems)
Use buttons to select the satellite to which your dish
is aligned. Press OK. An arrow will display against the
chosen satellite.
Press
button to navigate to LNB section of the menu.
Select the LNB type and settings for your LNB.
Press the Exit button and the
button to select the sec-
ond satellite.
Use
buttons to select the second satellite. Use
keys to select the satellite to which your dish is aligned.
Press OK. An arrow will display against the chosen satel-
lite.
Press
button to navigate to LNB section of the menu.
Select the LNB type and settings for your second LNB
and switch settings.
Press the Exit button and the
button.
Press the blue Key twice to search the satellite channels.
A full description of the advanced Dish set up for
multiple satellites using DiSEqC switches and DiSEqC
positioner follows. This should only be attempted by
experience users.
The Dish set up main menu page displays the main inter-
face. The interface consists of Satellite List, Transponder
list and Dish/LNB parameter list
Satellite List
The Satellite list displays the satellite names.
Satellite Edit
No. The current list number of the selected satellite Sat-
ellite name. The No. cannot be edited.
Satellite name: Press the green button to open the edit
menu explained below.
Extend: Extended characters
Caps On: Change character case. Press OK button to
select.
Back: Delete letters, press OK to c
OK: Sure to set the naming of the satellite, and return to
Edit Menu
Cancel: Return directly back to edit menu.
Longitude Direction: Added to determine the location of
the satellite. Use the
arrow buttons to select West/
East.
Longitude Angle: Input Longitude. By moving the cursor
tu buttons to enter the satellite longitude.
Band: band selection. Press
to select.
For editing via the on-screen keyboard, press the
but-
ton.
In the input frame, use
and OK button to select
characters.
Input Frame (On-screen keyboard)
To Next Page
Loading...
Need help?
General
