Seg Sydney - Instructions for Fixing Stand

Instructions for fixing stand
35
80cm (31.5”) LED-BLU TV Sydney
Note: the pictures below are only for reference
1. Put the rear board on the stand neck, and fix the rear board with the
screws supplied (4 x B4 x 12F).
2. Put the rear board on the rear cabinet of TV, and fix the rear board with the
screws supplied (4 x M4 x 14).
The parts
needed for installing the stand (supplied)
Installation
(Put your TV on the table with its rear cabinet facing upwards.)
Rear cabinet of TV
TV stand board
Screws(4xM4x14)
Screws(4xB4x12F)
The rear board
Screws: 2xB4X12F
Screws:
4xM4X14
Screws: 2xB4X12F
Front
Back