Basic Operation
QUICK START GUIDE
• Connection
1. Connecting the mains and antenna.
2. If TV has a power switch, turn it on firstly. Then press Power button on the remote to turn on the TV.
• First Time Installation
When the TV is initially powered on, a sequence of on-screen prompts will assist in configuring basic settings.
Trento 60cm LED BLU-TV
Press the / button to select Auto Tuning. Press the button to start Auto Tuning.▲▼ A step appears allowing you to set
parameters to the channels.
Country
Press the button to choose difference country, if the country you choose has DVB-C, the
option Digital Type will become DVB-C priory.
Tune Type You can choose different tuning type: ATV, DTV, ATV+DTV.
Digital Type
You can choose DVB-C or DVB-T in this option. This TV system is binding with country, if country
has DVB-C, it will choose to DVB-C priority. You can also choose DVB-T.
Scan Type
Press the button to choose Scan Type: Quick or Full. If you choose Quick, it read NIT table
when you have searched the first frequency. Then It will search other frequency according with
NIT table. If you choose Full, you can’t choose frequency, the searching range from 114MHz to
858MHz. The type of modulation is 64QAM, 256 QAM, 128 QAM, and 16 QAM.
Network ID
Choosing Auto it will achieve the frequency’s ID address automatically. Choosing 65535, you can
set the frequency on you own.
Frequency Enter a user-defined frequency. (Differs in each country)
Symbol Rate
Choosing Auto, it will search tune from symbol rate table. Choosing 6900, you can set the rate on
you own.
NOTE: If you choose the country that only have DVB-T, you can only choose Country and Tune type. The auto tuning are the
same as that you choose from the main menu in channel.
1. Press the
button to select the desired OSD (On Screen Display) language.
◄/►
◄/►
◄/►
To Next Page
Loading...
Need help?
General
