Step 2: Set up o-limit island
Go back to the starting point to nish the boundary mapping.6
Direction: Make sure the mower's right side (when moving forward) faces the boundary, so that the mower can cut as close to the
boundary as possible. The same goes for setting up the off-limit islands.
Slope: Even though the mower can traverse slopes up to 45% within the lawn, make sure the slope along the edge does not exceed 10%.
If there is a sudden interruption and failure, follow the instructions in the app to continue or restart.
If you have multiple separate lawns, please repeat this step.
How: Follow the instructions in the app. When you need to cancel the area (like when you remove the trampoline from the lawn),
just delete it via the app. See How to edit the map in 3.6 Settings (Mower).
When the mower hits a hard obstacle taller than 10 cm (such as big
rocks or a tree trunk), it will reverse and change the direction
automatically. However, you need to lay borders for objects that
need protection or areas you don't want the mower to enter, e.g. a
flowerbed, small trees, lawn decorations, pond, sprinkler heads,
emerged roots, etc. If you recently installed a trampoline or grill on
the lawn, you can also set an off-limit island to protect it.
Boundary
O-limit island
Channel
NOTE: Make smooth turning angle when setting the islands. The angle should not be smaller than 90°.
You also need to walk along the edge when setting the island. Refer to part 5 of Step 1.
25
To Next Page
Loading...
