The work area consists of boundary, O-limit Island and Channel.
Boundaries delineate one single complete work area, O-limit Islands delineate areas where the mower is prohibited, and Channels are
used to connect multiple work areas.
Inside the Channel, the mower will just pass through without cutting the grass.
The charging station and the GNSS antenna can be installed inside or outside the work area. If the charging station is outside the work
area, a channel straightly towards the nearest boundary will be automatically set once the map is completed. The mower will return to
the charging station using this channel. This channel cannot be edited or deleted.
2.4 Set up the Work Area
Follow the instructions in the app and remote control the mower to create the work area (referred to as the map in the manual).
The mower will smartly decide its moving pattern within the map.
NOTES:
If the location of the charging station or GNSS antenna is changed, the existing map CANNOT be used anymore and you MUST
create a new map.
Make sure your phone and mower are fully charged before mapping. Mapping will only start when the mower battery power level
is above 50%.
Boundary
Off-limit lsland
Channel
23
To Next Page
Loading...
