4
3
How to replace the blades
Turn off the mower.
To avoid scratching, place the mower on a soft and clean surface in an upside-down position.
Use a cross-tip screwdriver to loosen the three screws.
Remove the screws and blades.
1
2
Fasten the new blades and screws (Torque: 1 N·m). Make sure the blades can pivot freely.
5
Note: After fastening the blades and screws the blades will still seem loose. Refer to Blade in 1.4 Parts and Functions.
4.2 Replace Blades
If the mower is used on a regular basis, it is recommended to replace the blades and screws every 1–2 months to ensure safety and
better mowing results. Replace all three blades and their screws at the same time for a safe cutting system.
WARNING
Wear heavy gloves when you inspect or service the blade.
Only use the right type of screws and original blades as approved by Segway. Blade model: HA002E.
DO NOT reuse the screws. Doing so can cause serious injury.
48
To Next Page
Loading...
