BladeHalt
BladeHalt is a sensor that will be triggered when humans
or animals touch it. This is an experimental function and
will not guarantee 100% accuracy. The sensor is off by
default. It will be enabled when the sensor area is touched.
Meanwhile the blades will stop spinning automatically. This
sensor will only work when the blade disk is spinning.
NOTES:
When the mower is performing the edge cutting, the
BladeHalt sensor won't work.
We recommend disabling this feature when mowing for the
first time to ensure normal function because the sensor will
take tall grass as pets so that the blades will stop.
BladwHalt sensor
xxxxx
xxxxxxxxxxxx
How to reset PIN code
In factory settings, the default PIN code: 0000. You can
reset the PIN code in Settings>MOWER>Reset PIN code.
NOTE: It is recommended that you reset the PIN code
after activating your mower.
38
To Next Page
Loading...
