Hold the GNSS antenna to a place where you want to install it. Make sure that the top surface of the antenna points straight up.
When the signal indicator on the antenna becomes solid green, the signal is strong.
Make sure
there is nothing
blocking the
antenna.
For a wooden surface, just secure the base with the self-tapping screws.
For harder surfaces (like concrete, brick and stone), drill two 8 mm holes, insert the expansion tubes, and then secure the base
by tightening the screws.
You can rotate the
collars to adjust the
angle of the antenna
and the length of
the center column.
Top surface
4
Secure the installation base.
5
45
To Next Page
Loading...
