Segway Navimow User Manual

26
4
3
How to replace the blades:
Turn off the mower.
To avoid scratching, place the mower on a soft and clean surface in an upside-down position.
Use a cross-tip screwdriver to loosen the three screws.
Remove the screws and blades.
1
2
2
)
Replace Blades
If the mower is used on a regular basis, it is recommended to replace the blades and screws every 1–2 months to ensure safety and
better mowing results. Replace all three blades and their screws at the same time for a safe cutting system.
WARNING
Wear heavy gloves when you inspect or service the blade.
Only use the right type of screws and original blades as approved by Segway. Blade model: HA002E.
DO NOT reuse the screws. Doing so can cause serious injury.
Fasten the new blades and screws (Torque: 1 N·m). Make sure the blades can pivot freely.
5

Segway Navimow Specifications

General

Cutting Width	21 cm
Cutting Height	30-60 mm
Battery Capacity	5.2 Ah
Maximum Lawn Size	3000 m²
Slope Capability	45%
Waterproof Rating	IPX6
Connectivity	Wi-Fi, Bluetooth
App Control	Yes
Obstacle Avoidance	Yes
Weather Resistance	Yes
Noise Level	54 dB
Operating Time	Up to 3 hours