Try a test repair before attempting to repair the bucket. This will verify your technique without risking
damage to the bucket. It is much harder to fix a repair once a failed attempt has been made as the
hardened glue is difficult to remove.
Damage to the outer fabric coating, or pinholes which are not leaking, can be repaired with glue only. To
perform this type of repair, follow these steps:
1. Fill the weight bag with water prior to beginning repairs.
2. Clean the area to be repaired with an abrasive pad
dampened with solvent. Remove all traces of
masking tape, if previously used. If possible, place a
piece of masking tape on the back side of the item
being repaired.
3. Paint the damaged area with glue. Use a thick coat of
glue, overlapping the edges of the repair by 1" (25
mm). Be sure that the edges are well coated. A
damaged coating should be given two coats of glue.
Apply the second coat within four hours of the first
coat.
Damage to the base fabric must be repaired with a patch. To perform this type of repair, follow these
steps:
1. If there is dampness around the area to be patched,
then dry the area with a hot air fan or heat gun. Any
loose coating should be cut back with scissors.
Support the damaged area on a flat, solid platform.
This platform should be strong enough to support the
fabric (flat) and allow the patch to be rolled once it is
in place.
To Next Page
Loading...
Need help?
General
