Seiko Alarm Chrono
Cal. 7T32 - Setting Instructions
Created 05-07-2001
Refer to the instructions below for directions on how to set this watch
Note: your watch may have a different case or face than the one shown in the pictures.
The important thing is that they all share the same basic movement.
All Reset
All reset is used when first setting the watch or when there is unusual or erratic operation.
A - Pull Crown 1 out to the second click.
B -Press Button A and Button B simultaneously.
C - Push Crown 1 back in to the normal position.
Zeroing the hands
After all reset the hands and calendar must be "Zeroed" to provide a starting point for setting the watch.
A - Pull Crown 1 out to the second click.
B - * Press Button A to move the chrono minute hand to the zero position.
C - * Press Button B to move the chrono second hand to the zero position.
D - Push Crown 1 back in to the normal position.
E - After adjusting the zero positions proceed to adjusting time and calendar.
* Keep the button pressed to move the hand rapidly.
Setting the Date
A - Pull Crown 1 out to the first click.
B - Turn the crown clockwise until the date for the previous day appears.
To Next Page
Need help?
General
