Seiko C-26 User Manual

How to use the button
Some models may have a button which is recessed in the watch case to prevent accidental input.
Shape of the button differs depending on the design of the watch.
Upper half of the button is
covered.
Press the lower half of the button or
press the hollow in the middle
using an object with a long tapered
tip.
The button is covered except
the hollow in the middle.
Press the hollow in the middle
using an object with a long tapered
tip.
The button is recessed in the
watch case.
Press the hollow in the middle
using an object with a long tapered
tip.
EN
12
1
HOW TO USE
Crown
There are two types of crowns, a normal crown and a screw down crown.
Please check the type of the crown of your watch.
While
pressing the
crown in, turn it
in the direction
indicated by
the arrow.
The
crown
turns.
The crown
does not
turn.
Normal crown
Pull out the crown and operate it.
Screw down crown
Unlock the crown before
operating it.
After operating the crown,
lock it.
Unscrew
Rotate while
pressing
the crown in.
* By locking the crown by screw, a screw down crown can prevent malfunction and increase water resistance.
* Be careful not to screw the crown in by force as it may damage the slots of the crown.
EN
13
1
HOW TO USE
Before Use
1
Checking the Charging Status
When the movement of the seconds hand shows an energy depletion state, the battery requires
charging.
The seconds hand moves
at one-second intervals.
The seconds hand moves
at two-second intervals.
The seconds hand moves
at five-second intervals.
The seconds
hand is stopped.
The watch is
sufficiently charged.
The charged energy is depleted.
→ P.38
The power save function is activated. → P.
39
Check the movements of the seconds hand
after releasing the Power Save mode.
The energy stored in the watch runs low.
Charge the
battery
sufficiently.
How to charge
the battery
→ P.36
* If the seconds hand does not move at one-second intervals even after fully charging the battery, refer to
“Charging the solar battery” in Troubleshooting on P.74
EN
14
2
BEFORE USE
2
Checking the time and date
* When adjusting the time or date, refer to the following pages regarding the procedures.
When the time and
date are correct
Use the watch without
adjustment.
When the time
and date are
incorrect
Time zone
confirmation
→ P.30
When the radio
signal can be
received
Setting the time and date
by receiving a radio
signal → P.58
Radio signal reception range indication → P.
18
Environments in which it is difficult to receive a radio signal → P.
24
When a radio
signal cannot
be received
Manually set the time
→ P.61
Manually set the date
→ P.63
* When the watch does not display the correct time and date even after successfully receiving a radio signal, refer
to Troubleshooting.→ Misalignment of the time and hand positions P.74, and Misalignment of the date P.76
EN
15
2
BEFORE USE

Seiko C-26 Specifications

General

Brand	Seiko
Model	C-26
Category	Watch
Language	English