To Next PageTo Next Page
Need help?Do you have a question about the Seiko V157A and is the answer not in the manual?
Details the movement of the second hand in one-second intervals.
Specifies the driving system as a stepping motor.
Lists additional functions like instant-start, energy depletion warning, etc.
Describes crown positions and their functions for date/time setting.
Specifies the monthly rate of time loss or gain.
Indicates that the regulation system is 'Nil'.
Specifies the gate time for rate measurement as 10 seconds.
Details current consumption for movement and circuit block.
Provides the coil resistance range.
Details the power supply system including battery type and voltage.
States the number of jewels used in the movement.
Explains the watch's solar power generation system and operation.
Describes the second hand movement at 2-second intervals when battery is low.
Details immediate operation upon exposure to light.
Provides a table of charging times for different light sources and conditions.
Offers crucial advice to avoid damage from excessive heat during charging.
Lists major watch components with their corresponding numbers and names.
Explains how to select parts based on case design and catalog.
Lists essential tools like movement holder and watch oils for maintenance.
Provides general notes on disassembling and reassembling watch components.
Instructions on how to properly install the hour, minute, and second hands.
Guidance on setting and fixing the dial onto the movement.
Details how to remove the setting stem before dismantling the movement.
Instructions for disassembling and reassembling the dial holding ring and solar cell.
Step-by-step guide for assembling the contact spring for the solar cell.
Details on the assembling direction for the intermediate wheel for day setting.
Procedure for disassembling and assembling the date dial guard with hooking portions.
Instructions for removing and installing the rechargeable battery unit, including polarity notes.
Describes setting positions for yoke, setting lever, and stem installation.
Details on checking coil resistance and current consumption of the whole movement.
Procedure for measuring current consumption specifically for the circuit block.
Diagram illustrating the structure and terminals of the circuit block.
Steps to check the solar power generation system of the entire watch.
Procedure to test the solar power generation of the solar cell unit independently.
How to verify the instant-start function by checking battery voltage and light exposure.
Procedure to measure battery voltage before and after recharging to assess function.
Verifies the click and stem security during time setting operations.
Ensures smooth day and date changes when the crown is in the 1st click position.
Confirms the second hand stops when the crown is pulled to the 2nd click.
Checks for smooth movement of hour and minute hands without interference.
Ensures the date correctly changes as hour and minute hands pass midnight.
Details test methods and applied pressures for various water resistance ratings.
Procedure to measure the rate and ensure it is within ±0.50 s/d using a 10-second gate.
General
