Seko Dynamik Time - General Features; Functioning; Priming Mode; Working Mode

Dynamik Time
code: 0000136964 rev. 1.1
Dynamik Time
General Features

Functioning:
1) Pr
iming mode
(Switch position MOM / Priming) “Pump run for all time long that the switch is pressed”
2) Working mode
(Switch position ON / Run) “Wait trigger to start dosing”
Pump waits a “trigger” and the display shows
A_on
flashing
When the pump rec
eives a “trigger”, it start to dose and the display shows
Arun
flashing.
Pump can works in the following two ways:
A. Batch Dosing: the pump starts every time receive the external trigger and work only for the set active time:
a1. set A (activation time) from 1 to 60 min and P (pause time) to 0.
i) Example with A= 5 and P=0 minutes:
the pump doses for 5 minutes every time a trigger comes;
B.
Cyclic Dosing: the pump works cyclically until the trigger is present.
b1. 2) set A (activation time) and P (pause time) from 1 to 60 minutes
ii) Example with A= 5 and P=8 minutes:
the pump works for 5 minutes (ON) and stop for 8 minutes (OFF)
until the trigger is present;
3) Programming mode
(Switch position OFF / Stand
-
by) “Pump is stopped”
Press
Time
key to adj
ust dosing time limit:
1)
A
(Active
–
dosing time) from 1 to 60 minutes
2)
P
(Pause
–
wait time) from 0 to 60 minutes
Press
Dosing
to adjust flow rate pump:
A = Summer 4 l/h
B = Middle season 2 l/h
C = Winter 1 l/h
Customer may use this function to select the
desired dosing amount according to the season or to the period of use of
the swimming pool.
 Power Supply 100÷240 Vac
 Digital Display
 Priming (MOM), Run (ON), Stand-by (OFF) mode selectable by switch
 Flow rate 4, 2 and 1 l/h (at 1,5 Bar) selectable by programming menù
 External trigger 24÷240 Vac