Seko POOL BASIC EVO DOUBLE - Swimming Pool Application Overview; Alarm and System Settings

0000136904 rev. 2.0
6
Alarm
Display
Relay
Actions to do
Level
>3(3>####$OE#"+
Alarm Relay Close
- Push Enter Key to open
Alarm Relay
- Restore Product tank
OFA First Alarm (time >70%)
/@1#1>1.'##$OE#"+
Alarm Relay open
- Push Enter Key to reset
OFA Second Alarm (time =100%)
/@1#:;/"###$OE#"+
Alarm Relay Close
- Push Enter Key to reset
Flow Rate
H>/?#######$OE#"+
Alarm Relay open
- Restore Flow Rate
System Error
-1.1'3;3.#3../.P
Alarm Relay Open
- Press Enter Key to replace
Default parameter
- Destroy Unit
Calibration Function
I../.#$#"+
I../.#*#"+P
I../.#*,%#'(P
Alarm Relay open
- Restore Probe or Buffer
solution and repeat calibration
function
To restore Default parameters run Following steps:
• Power off Pool Basic unit
• Keeping Press UP and DOWN Key switch on the
Power.
• The unit will flash Q4<;)83@15>;##4/
•
Press up Q4<;)83@15>; ##R 3:
•
Enter Key to restore Default parameters.
Default parameters:
• Language = UK
• Set Point value= 7,4 pH; 750 mV (Rx)
• Dosing Method = Acid; Low (Rx)
• Time OFA = OFF
• Calibration = Full
• Flow Input= OFF
•
Type dosing= PROP
set
esc
enter
cal
prog