Seko PoolDose Single - Page 7

PoolDose | pH · ORP
0000138981 rev. 1.0 EN
5
Save and exit Program setup – Press
Pressing the key determines the exit from the programming menu with saving of the parameters, if the
parameter of the menu item in which one is in has not been changed when pressing the key.
Set Point adjustment
Press the button for 3 seconds, use and to set the desired value.
Stand-by mode (backlight on)
Press and buttons simultaneously for 5 seconds to switch off the unit backlight. Dosage and
calibration are disabled. To exit standby, press and buttons simultaneously.
Priming
Only while the pump is in stand-by press down and in the same time.
Flowrate counter reset
To reset value of "Partial Totalizer" press button for 3 seconds, in stand-by mode only.
OFA reset
Press the esc button for one click, reset countdown value.
Offset/Slope Menu
Press and buttons the unit show Offset/Slope calibration value, press or to scroll the
menu.
Note: Timeout setting menu, after 120 seconds without action the controller escape itself without saving parameters.
Display example:
7.2pH 32°C
LEV Ta 2546m
3
Alarm list
- Circ. Pump OFF
- LEV
- WDG
- OFA1 & OFA2
- Stand By
- Flow
- NO WiFi
Flow water totalizer
Absolut
Resettable
Temperature measure
pH measure
720 mV 32°C
LEV Ta 2546m
3
ORP measure
Flow water totalizer
Absolut
Resettable
Temperature measure
Alarm list
- Circ. Pump OFF
- LEV
- WDG
- OFA1 & OFA2
- Stand By
- Flow
- NO WiFi