Performer Operation Manual 15
1. Check the On / Off switch on the rear control panel is in the Off position.
2. Connect the power supply cable to a suitable clean mains power supply, checking that there is no
cable left in the cable storage compartment.
3. Switch the On / Off switch to the On position. There should be a buzzing noise of short duration as
the lamp is struck. If the buzzing noise is continuous, switch off the Performer Series Followspot, wait
5 minutes, and try again.
4. Check that the green earth continuity indicator on the rear control panel is illuminated.
Important Note: If the indicator is not illuminated, do not touch the Followspot.
Switch the Followspot off at the mains power supply, and contact a qualified
service agent.
5. When the lamp has struck, it may take up to 10 minutes for it to obtain its correct output and colour
temperature.
Fuse Holder / Circuit Breaker
The Circuit Breaker for the Performer Series 2 Followspot is integrated into the On / Off Switch. In the unlikely
event this needs to be replaced, this operation should be performed by a qualified service agent.
Manufacturer: E T A Rating: 16A
Part Number: 3120-F72R-N7M1-A30QB4 Selecon Order Code: FSELE006
Performer Lamp Specifications and Operating Notes
The Performer Series Followspot uses a short arc MSR Discharge Lamp.
Manufacturer: Philips
Type: MSR Gold 1200 SA/SE
Lamp Wattage Range: 800 – 1400 W
Lampbase: Patented
Lumen output at 1200W: 95,000 lm
Efficacy Source (1200W): 80 lm/W
Minimum ignition Supply Voltage: 207 V
Arc Size: 5mm
Philips Order Code: 9281 746 05100
Average Lamp Life: 750 hrs
Colour rendering index at 1200W 80
Colour temperature at 1200W: 6300K
Chromaticity coordinates (1200W) X: .318
Chromaticity coordinates (1200W) Y: .327
Replace only with the above lamp, which is available from your Selecon Dealer (Order Code MSRMINI)
Do not exceed the rated lamp life. Doing so will risk explosion of the lamp, and damage to the Performer
Series Followspot. This is not covered under warranty. Replace after 750 hours.
Please note that the quoted lamp life is a guideline only, and not an exact figure. In practise the lamp life is
reduced due to the following factors:
1. High humidity and ambient operating temperatures
2. Dusty / Dirty ambient operating conditions
3. Each On / Off cycle
4. Prolonged use at half or full (1400 W ) Power Output
Take care to read the operating instructions and warnings provided by the lamp manufacturer included with
your lamp, and follow the instructions for safe disposal of the lamp at the end of its operating life.
Version 2: January 2009 © 2009 Selecon New Zealand Limited. All Rights Reserved
To Next Page
Loading...