TEC Series v 3.2X
Page 38
This selection allows the keypad to remain active after dial out.
This is useful for answering machines, voice mail, and other
functions requiring a Touch-Tone™ signal after communications
are established. To enable keypad from the factory default of 0, press "7" from the Communications
Setup menu to get this sub-menu. Press "1" to enable the keypad, and press “*”. Only the number
keys are active, * and # will not work.applications, the talk time can be adjusted upward by pressing
"1" from the System Parameters menu to get this sub-menu. Key in the desired number (must be 2
digits) and press "*". This will return you to the System Parameters menu.
KEYPAD ON = 0
This selection allows all directory names to be suppressed from
the display. The codes keyed in will still display. All names will still
print to the optional printer (OPTKPRT). To disable Directory from
the factory default of 1, press "6" from the Communications Setup
menu to get this sub-menu. Press "0" to disable Directory, and
press "*".
DIRECTORY ON=1
DIRECTORY ON / OFF
CLOCK SETUP
There are three menu choices that are:
1. Set time and date.
2. Set time zone(s).
3. Set Holidays.
CLOCK SETUP
SELECT 1 - 3
SETTING TIME / DATE
Select "1" to set the time & date. You will be prompted to enter the current
time in minutes as a one or two digit number. If you make a mistake, press
"0" and "#" simultaneously to backspace one character. After the minutes
are entered, press the “*” key.
00:00 00/00/00
MIN.:
SPEAKER TONE
This selection allows the speaker to be activated for remote
control by a telephone Touch-Tone™ in order to listen in. When
enabled, the TEC has an open audio channel to permit
conversation from someone calling in to the TEC (the microphone is also enabled at the same time).
To enable speaker from the factory default of 0 (disabled), press "8" from the Communications Setup
menu to get this sub-menu. Select a digit from 1 to 9 to enable speaker, and press "*". This will
return you to the Communications Setup menu.
KEYPAD ON / OFF
SPKR TONE = 0
NOTE: ONCE TIME/DATE PROGRAMMING HAS BEGUN, ALL SELECTIONS MUST BE COMPLETED
FOR CHANGES TO TAKE EFFECT.
Enter a 1 or 2 digit number to set the hour. If a mistake is made, press "0"
and "#" simultaneously to backspace one character. After the hour is
entered, press the "*" key.
00:00 00/00/00
HOUR:
This is NOT the day of the month. This is a number which corresponds to
the day of the week. Enter a number corresponding to the day of the week.
Sunday is "1", Saturday is "7" and so forth. If you make a mistake, press "0"
and "#" simultaneously to backspace one character. After the day of the
week is entered, press the "*" key.
00:00 00/00/00
DAY, 1..7:
This selection allows information in the TEC memory to be
transferred to the display memory. Press 9 to enable update and
then press "*". This will return you to the Communications Setup
Menu.
UPDATING _
UPDATE LCD (TECVISION ONLY)
To Next Page
Loading...