TEC Series v 3.2X
Page 39
You will be prompted to key in the minute. This is a 1 or 2 digit
number between 00 and 59. If you make a mistake, press "0" and
"#" simultaneously to backspace one character. After the minute is
entered, press the “*” key.
00:00 00/00/00
YEAR:
You will be prompted to select a time zone between 0 and 7. If you
make a mistake, press "0" and "#" simultaneously to backspace one
character. Once programming of a time zone is begun, all choices
must be keyed in or you will be returned to the beginning of the time
zone menu.
A time zone is a period of time that limits when the TEC is valid. Use
this to control access to a facility, when a given condition is valid, based on:
1) The time of day.
2) The day of the week.
3) Whether or not the day of the week is a Holiday.
A time zone is valid only within a 24 hour period that begins at midnight. A time zone has a start time
and an ending time. This can be as short as two minutes, or as long as 24 hours. This time period is
valid in combinations from 1 to 7 days and Holidays. There are 8 time zones numbered 0 - 7
available for use on a TEC. Holidays may be set up at any time. A time zone can have valid
Holidays, or invalid Holidays. A time zone can be set that is only valid on Holidays, for applications
that require different hours of access on Holidays.
From the main menu, select "5" for clock setup, then "2" for time zone.
Enter a 1 or 2 digit number to set the month. If you make a
mistake, press "0" and "#" simultaneously to backspace one
character. After the month is entered, press the “*” key.
SETTING TIME / DATE continued
Enter a 1 or 2 digit number to set the day of the month. If a
mistake is made, press "0" and "#" simultaneously to backspace
one character. After the day is entered, press the “*” key.
Enter a 2 digit number to set the year. If you make a mistake,
press "0" and "#" simultaneously to backspace one character.
After the year is entered, press the “*” key.
You will be returned to the Clock Setup menu.
After the time zone is selected, press the “*” key. You will be
prompted to key in the hour. This is a 1 or 2 digit number. The hour
is expressed in 24 hour format (e.g., 2:25 P.M. is keyed in as 14:25),
from 00:00 to 23:59. If you make a mistake, press "0" and "#"
simultaneously to backspace one character. After the hour is
entered, press the “*” Key.
Next, enter the ending hour. This is a 1 or 2 digit number. If you
make a mistake, press "0" and "#" simultaneously to backspace one
character. After the hour is entered, press the “*” key. Press "0" and
"#" simultaneously to backspace one character. After the end hour is
entered, press the “*” Key.
TIMEZONE <0-7>
SETTING TIME ZONES
00:00 00/00/00
DATE:
00:00 00/00/00
MONTH:
START HOUR 00
START MIN 00
END HOUR 23
SETUP AND PROGRAMMING
To Next Page
Loading...