indicated on the characteristic plate of the equipment.
Do not use the equipment if it is NOT earthed.
MANUAL DE INSTRUCCIONES CODIGO 80104 REV F Marzo/2012 (Sujetas a modificaciones sin previo aviso) Pag.: 5
J
.P. SELECTA s.a. Autovía A-2 Km 585.1 Abrera 08630 (Barcelona) España Tel (34) 93 770 08 77 Fax (34) 93 770 23 62
e-mail: selecta@jpselecta.es
- http://www.jpselecta.es
PUESTA EN MARCHA:
- Seleccionar la temperatura de funcionamiento con las
teclas (5). La selección de temperatura se muestra
en el display (3).
CONTROL PANEL:
- Select the operating temperature with the keys
(5). The temperature selection is shown in the
display (3).
1. Led indicador funcionamiento compresor
2. Display lectura de temperatura
3. Display selección de temperatura
4. Tecla avance parámetros
5. Teclas modificación parámetros
6. Tecla salir de los menús
1. Running compressor led
2. Current t
emperature display
3. Set temperature display
4. Key to scroll parameters
5. Keys to modify parameters
6. Key to exit from the menus
OPERACIÓN
PANEL DE MANDOS:
OPERATION
CONTROL PANEL:
SEPARADOR
MUY IMPORTANTEANTES DE PONER EN FUNCIO-
NAMIENTO:
Colocar los topes separadores en la parte poste-
rior del equipo, para evitar que accidentalmente
quede demasiado adosado a la pared (ver dibu-
jo).
VERY IMPORTANT BEFORE THE FIRST START UP:
Put the buffers at the rear part of the equipment to
avoid contact with the wall (see drawing).
/ Silicone oil
/ Water
4
5
6
2
1
3
with the wall (see drawing).
1. Screen 1
2. Screen 2
3. Up/Down keys
4. Digit change key
5. Parameter change key
6. Parameter input key