Installation of the Select.live
1. Mount your Select.live on the wall as per the following requirements:
a. The ambient conditions at the mounting location must be suitable for the operation of the
Select.live (see Specification section)
b. The mounting location must have access to your Wi-Fi network if you are using a wireless
connection for Internet access.
2. Connect your Select.live to the SP PRO series II inverter using the supplied communication cable
as shown above to power the device and communicate with SP PRO.
For SP PRO Series I inverter, you must purchase the Select.live Adaptor kit for SP PRO Series I
(Order code: 005290).
The Gland and Sleeve must be used to fasten the Power Console
cable to the gland plate located at the bottom of the SP PRO as
shown.
To Next Page
Loading...
