Selenium DT 2006S - Page 9

4- DELAY –
a delay on the output channel selected (from 0 to 7 ms in intervals of
0.5 ms)
5- HPF&LPF –
adjusts the parameters of the High
Pass Filters (LPF).
The symbol
PARAMETER button. Press the same button to select another parameter. The
frequency intervals permitted for each one are as follows:
LPF 35 Hz to 22 kHz and HPF from 10Hz to 16kHz.
6- PEQ –
Parametric Equalizers: Up to 5 PEQs are allowed per output channel.
These filters may be of the following types:
HiShelf, LoShelf, and PEQ, as indicated on the DT2006S panel by "{", "}", and
.
The "=" symbol indicates
Move the cursor to the Q adjust and turn the PARAMETER dial to select the
Hishelf and Loshelf type filters.
The amounts permitted for each parameter are as follows:
Frequency: 20Hz ~ 20kHz
Q: 0.5 to 10
Gain: 12dB to +12d
HiShelf: 1kHz to 20kHz
LoShelf: 20Hz to 1kHz
7- LIMITERS –
have the following parameters:
LEVEL –
dB threshold
HOLD –
Time that the limiter continues active after the Threshold is up (ms)
a delay on the output channel selected (from 0 to 7 ms in intervals of
adjusts the parameters of the High
-
Pass Filters (HPF) and Low
Pass Filters (LPF).
indicates the parameter that will be changed by rotating the
PARAMETER button. Press the same button to select another parameter. The
frequency intervals permitted for each one are as follows:
LPF 35 Hz to 22 kHz and HPF from 10Hz to 16kHz.
Parametric Equalizers: Up to 5 PEQs are allowed per output channel.
These filters may be of the following types:
HiShelf, LoShelf, and PEQ, as indicated on the DT2006S panel by "{", "}", and
The "=" symbol indicates
that the filter is switched off.
Move the cursor to the Q adjust and turn the PARAMETER dial to select the
Hishelf and Loshelf type filters.
The amounts permitted for each parameter are as follows:
Frequency: 20Hz ~ 20kHz
Gain: 12dB to +12d
B
HiShelf: 1kHz to 20kHz
LoShelf: 20Hz to 1kHz
have the following parameters:
dB threshold
Time that the limiter continues active after the Threshold is up (ms)
9
a delay on the output channel selected (from 0 to 7 ms in intervals of
Pass Filters (HPF) and Low
-
indicates the parameter that will be changed by rotating the
PARAMETER button. Press the same button to select another parameter. The
Parametric Equalizers: Up to 5 PEQs are allowed per output channel.
HiShelf, LoShelf, and PEQ, as indicated on the DT2006S panel by "{", "}", and
Move the cursor to the Q adjust and turn the PARAMETER dial to select the
The amounts permitted for each parameter are as follows:
Time that the limiter continues active after the Threshold is up (ms)