SEM 200 - Page 19

semshred.com | 508.366.1488
19
11.) Torque bed knives to 45-50 ft./lbs.
• Requires torque wrench and 5/16” Allen drive socket bit.
• Torque wrench should not be used as a socket wrench and should be calibrated to
ensure proper tightening to avoid damage. SEM offers a complete toolkit for this
system.
• Double check knife clearance after torqueing bolts.
12.) Attach front and rear deflectors as shown with six 5/16-18” x 1 1/4" hex bolts and 5/16” lock
washers. Requires 1/2” wrench.
.001 Feeler
gauge
Figure 6.14
Figure 6.15