LUBRICATION
Important: To prevent jamming and/or clogging the shredder, it is necessary to frequently lubricate the
cutting unit and run it in reverse. For continuous shredding, the unit should be lubricated every 15
minutes.
Alternately run the machine forward and then in reverse several times to clean the cutting unit. Squirt
the SEM shred oil directly onto a piece of paper in a figure 8 motion, then feed into machine. Then run
it in reverse. This avoids getting oil into the optics. Too much oil is better than not enough. You are
again ready to start shredding.
MAINTENANCE
Two to three preventative maintenance calls per year are recommended. Only authorized service per-
sonnel should be allowed to service the shredder.
Important: Always unplug the shredder before performing any maintenance. If shredding capacity
drops or the machine jams easily, clean and lubricate the cutting system as outlined in the
"lubrication" section of this manual.
Maintenance Contracts: Check with your SEM sales representative for the maintenance to fit your
needs at 1-800-225-9293
391/2 391 P/2
16"
up to 19 Sheets
27 FPM
5/32 x 1 9/16"
115/1/60 1-1/2HP
391 C/2
16"
up to 6 Sheets
30 FPM
1mmx5mm
115/1/601-1/2HP
Feed Opening:
Maximum Feed:
Speed:
Shred Size:
Electrical:
Controls (for all):
16-
up to 23 Sheets
25 FPM
1/4 - Strip
115/1/60 1-1/2HP
Auto Start/Stop manual reverse.
Auto stop on bag full and door open.
36"H x 23-W x 18"0
115 Ibs.
Dimensions (for all):
Weight:
122 Ibs. 125 Ibs.
4.
To Next Page
Loading...
