What to do if SEM Paper Shredder shows Error 4?
If your SEM Paper Shredder displays Error 4, it means the waste leveling motor is locked. To fix this: 1) Turn OFF the breaker. 2) Check the waste basket and empty it if it's full. 3) Turn ON the breaker.
What to do if SEM 1201CC shows Error 8?
If your SEM Paper Shredder displays Error 8, it indicates that the overheating prevention of the controller is activated. You should: 1) Turn OFF the breaker and wait for a certain period of time. 2) Turn ON the breaker. 3) If the error persists, contact SEM’s Customer Service at 1(800)225-9293.
How to fix Error 1 on SEM 1201CC Paper Shredder?
Error 1 on your SEM Paper Shredder means that paper or a foreign object has been left in the feed opening without shredding for about 3 minutes, causing the machine to lock up. Here’s how to resolve it: 1) Turn OFF the breaker and pull out the plug. 2) Remove the paper or foreign object from the feed opening. 3) Turn ON the breaker again.
What does Error 2 mean on my SEM 1201CC and how to fix it?
Error 2 on your SEM Paper Shredder indicates that after the auto-reverse function was activated, paper remained at the feed opening for about 2 minutes, causing the machine to lock up. To solve this: 1) Turn OFF the breaker and pull out the plug. 2) Remove the paper at the feed opening. 3) Turn ON the breaker again.
Why does my SEM 1201CC show Error 3?
Your SEM Paper Shredder shows Error 3 because it has been operated continuously for more than 30 minutes, causing the machine to temporarily lock up. To resolve this, follow these steps: 1) Turn OFF the breaker. 2) Turn ON the breaker again.
What does Error 6 or Error 7 mean on SEM 1201CC Paper Shredder?
Error 6 or 7 on your SEM Paper Shredder indicates a malfunction of the controller. To attempt to resolve this: 1) Reset the breaker. 2) If the error persists, contact SEM’s Customer Service at 1(800)225-9293.
What does Error 9 mean on SEM Paper Shredder?
Error 9 on your SEM Paper Shredder indicates a problem with the LCD. To attempt to resolve this: 1) Reset the breaker. 2) If the error continues, contact SEM’s Customer Service at 1(800)225-9293.
Motor overheat protection cuts off power when locked or overloaded. Machine stops and beeps.
Prevents shredder operation when the cabinet door is open for safety.
Shredder stops automatically when the waste basket is full.
Shredder stops and reverses automatically if sheet capacity is exceeded.
Protects motor from burnout and overload during circuit failure.
Prevents operation while jammed paper is removed via feed opening.
Sounds on acceptance of key entry and when the machine status changes.
Intermittent beep every 5 seconds when paper/foreign articles detected.
Informs status changes like leveling waste chips or errors.
Procedure for operating the shredder automatically using the START key.
Procedure for operating the shredder manually via the START key.
Procedure for operating the shredder in reverse using the REVERSE key.
Procedure for emptying the waste basket and handling full waste levels.
Details of error codes, their causes, and corrective actions.
Solutions for common issues like shredder not starting or stopping.
General| Brand | SEM |
|---|---|
| Model | 1201CC |
| Category | Paper Shredder |
| Language | English |
To Next Page
