OPERATING PROCEDURES Cont…
Manual Operations
Procedure Display
The cutters stop automatically
approximately 10 seconds after the paper
disappears from the feed opening and the
screen changes to SHRED READY.
For continuous shredding, feed the next
paper within 10 seconds.
To stop the shredding during operation,
press the STOP key. The cutters will be
stopped. If the paper has disappeared from
the feed opening when the STOP key is
pressed, the screen (a) is displayed. If it
remains, the screen (b) is displayed. In this
status, the alarm beeps continuously
sounds.
After using the shredder, turn OFF the
main breaker and pull out the plug from the
outlet.
Reverse Operation
Procedure Display
Reverse operation is possible while one of
the following 3 screens displays
ϖ SHRED READY
ϖ SHRED RUNS BY START KEY
PRESS or
ϖ OVERLOADING: REMOVE
PAPER.
Press the REVERSE key. While you are
pressing the key, the cutter rotates in
reverse direction.
For NATIONWIDE SERVICE call 1(800)225-9293
15
I
SHRED
READY
a.
I
SHRED
READY
b.
SHRED
RUNS
BY
START
KEY
PRESS
SHRED
READY
I
SHRED
RUNS
BY
START
KEY
PRESS
OVERLOADING:
REMOVE
PAPER
fIiiI1
a Icons light
o
04~
l:!!J
up
by
turns
REVERSING
https://www.supplychimp.com
To Next Page
Loading...
