Why won't my Senco Power Screwdriver drive screws?
If your Senco Power Screwdriver won't drive screws into the material, it might be because the bit is worn out. Try replacing it. Also, make sure you're not asking the tool to do more than it's designed for; check the operator's manual for suitable applications.
What to do if my Senco DuraSpin DS200-AC won't start?
If your Senco Power Screwdriver won't start or is running slowly, the trigger switch may be defective, in which case you should return it to Senco. Also, ensure that the tool is receiving electrical power by checking the electrical supply and fuse.
Ensure adherence to safety warnings and instructions for tool usage.
Utilize polarized plugs correctly and handle cords with care.
Adjust depth control for proper countersink and test with a screw.
Unplug tool before adjusting nosepiece for correct fastener length.
Identifies problems like tool not starting, slow operation, or poor screw driving.
Addresses issues like tool not starting, slow running, or battery problems.
Solutions for screws not driving, falling out, or improper seating.
Troubleshoots issues like stuck mechanisms, bit alignment, or overheating.
General| Power Source | Corded Electric |
|---|---|
| Voltage | 120 V |
| Fastener Range | #6 - #12 |
| Spindle Lock | No |
| No Load Speed | 0-2, 500 RPM |
| Screw Length | 1" - 2" |
To Next Page
