M
Matthew HayesAug 11, 2025
What to do if Senco Power Tool is jamming?
- Bbrenda89Aug 11, 2025
If your Senco Power Tool is jamming, you should clean the tool, lubricate the magazine, or install Parts Kit D.
To Next PageTo Next PageWhat to do if Senco Power Tool is jamming?
If your Senco Power Tool is jamming, you should clean the tool, lubricate the magazine, or install Parts Kit D.
How to fix a Senco S150LS with air leak?
To address an air leak near the top of your Senco Power Tool accompanied by sluggish operation, verify the air supply and tighten the screws, or install Parts Kit A.
How to fix weak drive on Senco Power Tool?
To fix a weak drive on your Senco Power Tool due to a broken or worn driver, verify adequate air supply or install Parts Kit C.
General| Type | Finish Nailer |
|---|---|
| Fastener Range | 1-1/4" to 2-1/2" |
| Operating Pressure | 70 - 120 psi |
| Category | Power Tool |
| Gauge | 15 gauge |
