To Next PageTo Next PageWhat to do if my Senco SLS150Mg Power Tool leaks air near the bottom or has poor return?
If your Senco Power Tool leaks air near the bottom or has poor return, clean the tool. You might also need to tighten the screws or install Parts Kit YK0852.
Employers must enforce safety warnings and instructions and keep the manual available for tool users.
User must stay alert, use common sense and avoid operating tool when tired or under influence.
Never use tool in explosive atmosphere or with combustible materials like liquids, gases or dust.
The depth of drive is set by turning the dial under the trigger for desired penetration.
The SLS150Mg has an LED headlight that can be turned on or off with the red button.
Tools offer adjustable trigger for Contact Actuation (Dual-Action) or Sequential Actuation (Restrictive) modes.
Adjust the exhaust air direction by turning the deflector to the desired location.
Keep all screws tight to ensure safe operation and prevent parts breakage.
Inspect safety element and trigger movement daily with tool disconnected; do not use if they stick.
Wipe tool clean daily and inspect for wear. Use non-flammable cleaning solutions if necessary.
Troubleshoot air leaks near the top or sluggish operation by verifying air supply or tightening screws.
Address air leaks near the bottom or poor return by cleaning the tool or tightening screws.
For any other problems not listed, contact SENCO customer support.
Employers must enforce safety warnings and instructions and keep the manual available for tool users.
User must stay alert, use common sense and avoid operating tool when tired or under influence.
Never use tool in explosive atmosphere or with combustible materials like liquids, gases or dust.
The depth of drive is set by turning the dial under the trigger for desired penetration.
The SLS150Mg has an LED headlight that can be turned on or off with the red button.
Tools offer adjustable trigger for Contact Actuation (Dual-Action) or Sequential Actuation (Restrictive) modes.
Adjust the exhaust air direction by turning the deflector to the desired location.
Keep all screws tight to ensure safe operation and prevent parts breakage.
Inspect safety element and trigger movement daily with tool disconnected; do not use if they stick.
Wipe tool clean daily and inspect for wear. Use non-flammable cleaning solutions if necessary.
Troubleshoot air leaks near the top or sluggish operation by verifying air supply or tightening screws.
Address air leaks near the bottom or poor return by cleaning the tool or tightening screws.
For any other problems not listed, contact SENCO customer support.
General| Brand | Senco |
|---|---|
| Model | SLS150Mg |
| Category | Power Tool |
| Language | English |
